Cold formed steel framing members usee for

The methods of bracing may be categorized into three groups: tension systems, tension-compression systems, and compression systems. Several bracing concepts are available to effectively brace axially loaded CFS against both flexural and torsional buckling modes. As a result, AISI S211 uses a more conservative strength requirement, 2%, compared to 1% in equation D3.3-1 in AISI S100. When using AISI S211 approach, there is no explicit brace stiffness requirement compared to the approach in AISI S100. L b = Distance between braces on individual concentrically loaded compression member to be braced,ДЄISI S211 Section B3.1, Intermediate Brace Design, states that: вЂњFor axially loaded members, each intermediate brace shall be designed for 2% of the design compression force in the member.вЂќ N = Number of equally spaced intermediate brace locations О’ rb = Minimum required brace stiffness to brace a single compression member P ra = Required compressive axial strength of individual concentrically loaded compression member to be braced P rb = Required brace strength (brace force) to brace a single compression member with an axial load P ra While the required brace stiffness for LRFD and LSD design methods is given as: The required brace stiffness for the ASD design method is given as: The required strength of the brace to restrain lateral translation at a brace point for an individual compression member is given as:

The design requirements for the bridging components of axially loaded cold-formed steel studs are described in the North American Specification for the Design of Cold-Formed Steel Structural Members, AISI S100-12, Section D3.3, and Section B3.1 of the North American Standard for Cold-Formed Steel Framing вЂ“ Wall Stud Design, AISI S211-12.ДЄISI S100 Section D.3.3, Bracing of Axially Loaded Compression Members, gives both a strength and stiffness design approach. Brace forces for studs with combined axial and lateral loading are additive, and the designer is encouraged to refer to The American Iron and Steel Institute (AISI) design guide, Cold-Formed Steel Framing Design Guide (AISI D110-16) where a design example showing the interaction check for combined loading condition can be found. It should be noted that bridging requirements for studs loaded laterally, perpendicular to the plane of the wall, are not discussed herein. Also, for axially loaded walls, it is an industry practice to disregard gypsum sheathing as a structural brace because of durability issues associated with possible water damage. One primary reason that CFS walls in mid-rise buildings require an all-steel design bridging approach is that the lower floors may go unsheathed for weeks at a time during construction. The all-steel design approach indicates that the CFS studs rely on bridging for stability and that bracing by structural sheathing or gypsum wallboard is not typically considered for axial load stability in the design. The bridging methods described herein represent a mechanical bracing design consistent with an вЂњall-steel designвЂќ approach. Bridging is used within the plane of the wall to prevent global buckling and specific performance requirements of the bridging must be maintained.

Global buckling of an axially loaded stud can occur in one of three modes: flexural buckling, torsional buckling, or flexural-torsional buckling. Thus, it is more critical to the integrity of the structure that these heavily loaded studs be adequately braced. As our understanding of the behavior of CFS studs continues to evolve, the height of a typical mid-rise CFS structure continues to increase. In recent decades, CFS design has evolved tremendously as the behavior and design constraints of the material continue to be better defined through comprehensive research and testing. Cold-formed Steel (CFS) studs provide a cost effective and extremely efficient structural solution for the typical mid-rise building. This article provides a better understanding of the design requirements and methods to laterally brace (bridge) axially loaded cold-formed steel stud walls.

Cold formed steel framing members usee for